当前所在页面:首页 > 公司新闻 >The 3axis cnc machine motor will not be damaged
The 3axis cnc machine motor will not be damaged
Many advertisers have caller told us the machine bought half a year, feeling up and running Kaka ! Pole using Caltex, 50 yuan a bottle of butter , where Xin Xin 3axis cnc machine manufacturers technical advice 3axis cnc machine using the user , do not wait until the machine if the run up Kaka was oiled , and that even if the run-in period is finished, years of life lost at least 1-2 years.
Also 3axis cnc machine technology strongly oppose the use of inferior oil butter plus inferior , to know a bird machine screw ball bushing there are many , if not maintained , and so screw marks appear on a Daura regretted . There is a lubricating grease called snow . First on the W-40, Space walk, clean the screw , and then butter stress that the oil right up a touch on it.
In addition, we use 3axis cnc machine at the time , to maintain a good 3axis cnc machine cleaning work , this will effectively extend the life of 3axis cnc machine !
So long as no more than 130 degrees , the 3axis cnc machine motor will not be damaged. Internal temperature we may not be able to accurately measure , but we can measure the surface temperature of the motor . When the internal temperature at 130 degrees, 3axis cnc machine 90 degrees in the external . Therefore , the 3axis cnc machine stepper motor surface temperature of 70-80 degrees is normal. Useful for simple temperature measurement point thermometer , 3axis cnc machine can roughly judge: hand can touch more than 1-2 seconds , no more than 60 degrees ; hand can touch, about 70-80 degrees ; few drops rapidly gas of , 3axis cnc machine the 90 degrees of .
Stepper motor temperature is too high will lead to 3axis cnc machine3axis cnc machine occur during normal operation dislocation . So it is best to run continuously in the machine a few hours later, the machine a short break.